Recent content by D1N0##

https://www.facebook.com/groups/fosiaudiocommunity/permalink/869973711556664/

Did you hear a difference with just the power supply, not the Sparkos yet?

When you can put the V3 mono sideways you can get some convection going in the body, also you could integrate an auxiliary heat sink against the bottom (but now the side) of the unit so it would remain cool. With a little creativity it would also look very cool.

Am I right to say there is basically still a pre-amplication stage in the V3 mono. Just no volume attenuator, but the op-amps will pre-amp the signal to the chip.

the sooner the better 😛

Something like the Schiiit Freya + but with dedicated sub out (double) and a variable high pass filter. I can do without a passive preamp function, but the possibility of op amp rolling should be added. With op-amps + tubes you can tailor it to you needs and preferences. Class A would be great.

From the Facebook community https://www.facebook.com/photo?fbid=7273450586073619&set=gm.837437854810250&idorvanity=427411122479594

Look out for the kickstarter

Ideally you would run the sub of a pre-amp. You could use one of the ZA 3's sub outs of course but then you will miss a channel (low frequency is usually on both channels so it shouldn't matter much). Or you could use the speaker level inputs so from Both ZA3's into the sub and then to your...

You will know for sure when purchasing from a legit outfit recommended by the manufacturer: https://www.nisshinbo-microdevices.co.jp/en/MUSES/series/MUSES02.html

Just try it out. I guess. Put it in the xlr in one and in the right channel in the other and listen (not at the same time and both amps in mono).

It serves as a differential amplifier. The two signal cables of the xlr carry an out of phase signal and random noise from interference. The opamp substracts the noise from the signal because it is largely the same for each signal cable. The noise in the left cable is in phase with the noise...

The player seems pretty light to me. To reduce vibration I would like to see wall mounting holes on the bottom so wall mounting or mounting on heavy base of some sort is possible.

Looks like it's balanced. Would it not be more logical to brand it in the Z series?

I asked bard if it could be used for cancelling out interference. Of course I do not know if it is telling the truth or just making stuff up since it doesn't seem to know the difference. For verification reasons I asked it: Answer