Monkey96
New member
Hello all. A strange occurrence here.
I have a pair of V3 monos with separate 48v/10a PSUs. It's fed by an RME DAC via XLR.
I set them up yesterday and was immediately impressed with them. I added heatsinks to the tops of the cases to keep them nice and cool. All good.
Today I messed around with my speaker positioning and had a good listening session, then later switched off the music and watched the TV (also running through the DAC). All good.
I then realised that I hadn't put the DC filters in the chain, so switched off the V3s, added the filters in the chain, and then powered them on.
No audio output from either amp.
So I switched them off, disconnected the filters, and reconnected the PSUs.
No audio output from either amp.
They power on as usual, speaker circuit check relays click, RCA to XLR selector relays click, LEDs on; all fine. But no audio.
Everything else in the chain is fine. DAC showing signal (it has a display on it which shows all is normal). No loose connections. When I power on the amps, there's even the normal 'pop' slightly audible through the speakers. But no audio.
Any ideas anyone?
I have emailed Fosi but thought I'd ask on here.
Thanks.
I have a pair of V3 monos with separate 48v/10a PSUs. It's fed by an RME DAC via XLR.
I set them up yesterday and was immediately impressed with them. I added heatsinks to the tops of the cases to keep them nice and cool. All good.
Today I messed around with my speaker positioning and had a good listening session, then later switched off the music and watched the TV (also running through the DAC). All good.
I then realised that I hadn't put the DC filters in the chain, so switched off the V3s, added the filters in the chain, and then powered them on.
No audio output from either amp.
So I switched them off, disconnected the filters, and reconnected the PSUs.
No audio output from either amp.
They power on as usual, speaker circuit check relays click, RCA to XLR selector relays click, LEDs on; all fine. But no audio.
Everything else in the chain is fine. DAC showing signal (it has a display on it which shows all is normal). No loose connections. When I power on the amps, there's even the normal 'pop' slightly audible through the speakers. But no audio.
Any ideas anyone?
I have emailed Fosi but thought I'd ask on here.
Thanks.