Recent content by joergasmussen

From https://www.panasonic.com/mea/en/consumer/home-entertainment/audio/mini-systems/sc-ux100.html I find Have you installed that app? But then again, the BT30D Pro (36V version) is notoriously difficult to connect to savely, as it does not require a confirmation prompt. I had the BT30D Pro...

Will it have socketed op-amps?

Moin aus Dänemark :) When I order your specked Monos here on Fosiaudio.com, I have to pay almost $900 (before bundles/coupons). That is pretty close to 1000€ Just sain' :D

Where do you find these binary files? Could you link to a support page or description? Just a bin-file does me no good.

I have observed the same. But not often. I use USB. Since November 2024 until now I have heard it a handful of times.

I use the BT30D Pro in a desktop setting at work and have a problem with my BT30D being open for connections from my co-workers. All the sudden their laptop audio output blast out of my speakers. Pretty annoying, if you ask me. Is it possible to disable the BT completely? I tried wrapping the...

If it was true that the 3255-chip operates better hot, should I place my Fosi BT30D Pro in the oven at 60°C to expect better sound? It is never warmer than my V3 Monos with a fan sandwiched between them, about 28°C. My Monos get about 60°C hot without the fan, even when idling. One of my monos...

I have a supplement: the above statement regards using XLR as input. When using the RCA-cables, one powers off after about 5 minutes, the takes >>10 minutes to power off. The one that is late turning off is also experiencing sporadic turn-ons and often keeps on for long time.

Did you observe differences when using XLR vs. RCA? I have a ZD3 with V3 monos. The first time I tried the RCA (with very cheap cables) I was sure I heard a big difference to XLR. Later I bought some more adequate Roland RCA-cables, and now I don't seem to hear a difference. Btw, I have a SVS...

What is the purpose of the Txx? I read the above description and can't figure out what this device should accomplish. Are you suggesting a fan-controlling device, and nothing else? I am all in for some better cooling, as I have a fan installed between my V3 monos. But, by any means, Fosi, the...

I'm guessing, but they seem to draw very little power. Any USB phone charger you have should work. I saw pictures on Amazon stating one fan uses 5V and 0.15A.

I can't tell if they need a fan. I ran my set without fans for 2 months. I didn't have a thermometer, but I guess the temperature was around 40-50 °C. One of them broke down during a startup (it was not warm at all). Fosi Support sent me a replacement board and I ordered the fan package. Now the...

So the fans didn't prevent a breakdown of a block? I just received the replacement board and a set of fans. The fans do a pretty good job. The blocks seem to hold a steady 30°C.

I have used V3 monos for almost 2 months. In the beginning, I tried to place them stacked, but I found them getting uncomfortably hot. Then I placed them side by side with 1 inch of space between them. The auto-feature works perfectly here. Both turn off within the same second. I use them in an...

I have 1 mono broken down after almost 2 months of everyday use. After a startup, the block was still "cold", I heard a noticeable click and no more sound. The other one works fine. After contacting support@fosiaudio.com they promised to send me a new soundboard, so I can swap the defective one...