Hi team, I'm having some dramas with a T10 WiFi & Bluetooth 5.0 Amplifier 2 CH. I originally went through the setup process using WiiM (which was painful, but managed to get it connected to my wifi) but I didn't set the device name. I've been trying to run the setup again but cannot - I've used WiiM as well as 4Stream (as advised by the WiiM support) but the Fosi does not provide an open network anymore - it's now "Fosi Audio T10_[last four digits of the MAC address]" and it now requires a password to access it.
Questions:
- Is there a method to do a factory reset? There's no pinholes on the box nor references anywhere
- Is the password available for the T10's own network, and - if I can join this networks - can I run the setup again?
- I can see both interfaces (wifi and LAN) and they are both open for http/https traffic - is there a web config page that I can use?
This is very frustrating, and should be much simpler than it actually has been.
Thx Mark
Questions:
- Is there a method to do a factory reset? There's no pinholes on the box nor references anywhere
- Is the password available for the T10's own network, and - if I can join this networks - can I run the setup again?
- I can see both interfaces (wifi and LAN) and they are both open for http/https traffic - is there a web config page that I can use?
This is very frustrating, and should be much simpler than it actually has been.
Thx Mark