Amplifier MC331 DSP software

[doxygenthief]

It is possible to connect to the MountainView DSP chip in the MC331 using ACP workbench. (The DSP chip is probably a BP1048 or similar like the ones used by Wondom BRU, Arylic, Eiffelton etc.)

This program allows for adjustments to EQ, Virtual Bass, Stage effects, harmonic excitation, noise reduction etc. The version of ACP I am using is 2.39.9 which works well up to the point of saving changes. I followed the onscreen prompts but have not been able to make permanent changes.

Is there an official Fosi version of the ACP workbench software that allows changes to the DSP to be saved to the device?

 

[viktor1212us@gma]

I also try with Acpworkbench and I can't save settings,i have problem with distortion on analog input when i feed with smsl dac su 1(2 vrms) output,sound is too loud with little distortion,i like to lower input a little,also volume control steps is to high, between third and fourth steps increase to much volume,the steps need to be more linear.Also amplifier don't remeber last volume gain and when i turn off and turn on volume is too high,i hope that this issues will be fix with firmware update.