Nuky^^
New member
Hi all,
I am setting up my first audio setup for my PC. I have the following setup in mind after some research and wanted to confirmed if this setup is doable. I should add, i already purchased all the items and GenAI seem to throw me a curve ball with what appears to be mistake on its part so I am quite worried now....
I am setting up my first audio setup for my PC. I have the following setup in mind after some research and wanted to confirmed if this setup is doable. I should add, i already purchased all the items and GenAI seem to throw me a curve ball with what appears to be mistake on its part so I am quite worried now....
- PC to ZD3. ZD3 will be set to bypass mode, hence using it solely as DAC. Connection is via USB.
- ZD3 to ZP3. Using ZP3 as the main control hub to adjust the audio. The connection is via XLR. Tigger cable between the two as well.
- ZP3 to NobSound V1-XLR. I decided to get this over fear of the volume on ZP3 being reset and send a huge signal to my speak. Hence, this is really just for protection. I will set the volume and never touch it again. Connection is via XLR.
- NobSound V1-XLR to two V1 Mono. Connection is via XLR. The V3 is powered by separate 48V/5A PSU.
- V1 Mono to Starke Sound Beta 5 (long story but the above setup was meant for a bigger speaker and I decided to switch from a bigger speaker to a smaller one eventually).
Last edited:
